技術中心
Technological Center
裝機條件：
the Installed Conditions
    主機一臺套，輸入電源380V,輸電能力不低于15千瓦，工房80m2，混凝土場地150-200m2（設備基礎見圖，設備不需地角螺栓固定。）
One set/unit of main engine, 380V’s input power, and the transmission capacity is not less than 15KW. The workshop area is 80㎡ and the area of concrete ground is 150-200㎡。(You can refer to drawings for the equipment foundation, and the equipment does not need foundation bolt)

技術特點：
Technological Features
1. 任何一臺主機只換模具、壓頭便能生產D20-D140cm的各種U型、1/2U型渠道構件、梯形構件等。
Any main engine can produce all kinds of U shape and 1/2U shape channel components and trapezoidal members with Dia. from 20 to 140mm
    2.矩形、多邊砌塊、建筑用空芯砌塊及免燒磚等。
The equipment can produce rectangle, variable and baking-free bricks and hollow bricks for buildings.
    3.模具裝置于主機上，所產構件當即脫模、立式養護。
The mold is fixed in the main engine. And it can be removed as soon as it finishes components so it is easy to be maintained.
施工要領：
Essentials to Construction
1. 依據設計要求，每30米設一龍門樁，以所砌渠板外形為準，渠槽形同所砌U型板，精修渠床（切勿挖大）。
According to designing requirements, put up a gantry pile every 30m as the dimension of channel plate. The shape of channel is the same and U-shape plate. The channel should be trimmed exactly(not too big)
    2.建議：砌襯板時底鋪設75#水泥砂漿3-4cm厚寬度不小于20cm，縱橫接縫寬度2.0-2.5cm。
Advice:
When build lining plate, its bottom is laid by 75#cement mortar with thickness of 3-4cm, width of more than 20cm and width of longitudinal and transverse joints are 2.0-2.5cm. 
    3.構縫前用水將接縫外沖洗，涂水泥漿一層，1：2.5水泥砂漿構縫（推薦摻加水泥含量12%的膨脹水泥）。
Before filling the joints, please wash them and coat with cement paste. Then fill the joints with cement mortar of 1:2.5.( Suggestions: using expansive cement with cement percentage of 12)
    4.渠邊護土，要求粒狀不大于20mm，密實、均勻、平整。
Fill earth ( Dia. Less than 200mm)  beside the channel equably, smoothly and tightly.
　
注：特殊規格特殊定做！
Note: We can produce customerized machines.